Description
The EX-9510H (RS485)/ EX-9510AH (RS422) repeater boosts the RS-422/485 signals to extend the reach distance up to 4000 ft (1200m) and increase the maximum number of connected nodes up to 128.
With a special circuitry, EX-9510H/AH is able to automatically detect the data flow and switch the direction of the data lines accordingly.
“Auto baud rate detector” enables EX-9510H/AH to automatically configure RS-422(EX9510AH)/485 signals to any baud rate without external switch setting.
Build in Opto-isolations on EX-9510H/AH provides 3000VDC of isolation to protect the host computer from ground loops and destructive voltage spikes on the RS-422(EX9510AH)/485 data lines.
EX-9510H/AH also offers internal surge-protection on the data lines. Internal high-speed transient suppressors on each data line protect the module from dangerous voltages levels or spikes.
Features
- Automatic internal RS-422(9510AH)/485 (9510H) bus supervision
- No external flow control signals required for RS-485
- Minimum 3000VDC isolation protection
- Transient suppression on RS-485 data lines
- Supported baud rate (bps): 1200, 2400, 4800, 9600, 19.2K, 38.4K, 57.6K, 115.2K
- Reach distance up to 4000 feet (1200m)
- Reserved Internal space of PCB for soldering termination resistors (R8,R9), it also can connect the terminator (110/220/330 Ohm)
- between D+ & D- on external terminal block of both side . In general that Terminator was requirement during extend the Distance & Module numbers (it was match the network Impedance) .
- Power and data flow indicator for troubleshooting
- Power requirement: +10V to +30VDC
- Mounts easily on DIN-rail or panel
- Plug-in screw terminal wiring: Accepts AWG 1-#12 to #22 (0.5 to 2.5mm) wires
- Power consumption: 2.2W
- Operating temperature: 0~70 °C
- Storage temperature: -25~85 °C
- Humidity: 5~95%, non-condensing
